| 空压机系统缺油 |
| 添加时间：2022/2/11 14:17:44 浏览次数： |
| 空压机系统缺油。可检查油气桶油位，在停机泄压后，润滑油处于静态时，油位应比高油位标志H（或MAX）略高。在设备运行过程中，油位不能低于低油位标志L（或MIX）。如发现油量不足或观察不到油位时，应立即停车加油 The air compressor system is short of oil. Check the oil level of the oil and gas tank. After shutdown and pressure relief, when the lubricating oil is static, the oil level should be slightly higher than the high oil level mark H (or max). During the operation of the equipment, the oil level shall not be lower than the low oil level mark L (or mix). If it is found that the oil quantity is insufficient or the oil level cannot be observed, stop the machine immediately to refuel 三、油停止阀（断油阀）工作不正常。油停止阀一般为两位两通常闭电磁阀，起动时开启，停机时关闭，（atlascopco机器为机械式开启阀）以避免停机时油气桶内的油继续喷入机头，并从进气口喷出。若该元件加载时不开启，主机会因缺油迅速升温，严重者会造成螺杆总成烧毁。 3、 The oil stop valve (oil shutoff valve) is not working properly. The oil stop valve is generally a two position two closed solenoid valve, which is opened when starting and closed when stopping (Atlas Copco machine is a mechanical open valve) to avoid the oil in the oil and gas barrel from continuing to spray into the machine head and from the air inlet during shutdown. If the element is not opened when loading, the host will rapidly heat up due to lack of oil, and in serious cases, the screw assembly will be burned. |
| 上一页 空压机卸载后空压机高温 |
| 下一页 环境温度过高对螺杆空压机造成高温 |
Copyright © 技术支持：遨游网络